Basic Call Features; Answering A Call; Call Mute And Un-Mute; Call Hold And Resume - Yealink T42G Quick Start Manual

Basic Call Features

Placing a Call
Using the handset:
1. Pick up the handset.
2. Enter the number, and then press the Call soft key.
Using the speakerphone:
1. With the handset on-hook, press
2. Enter the number, and then press the Call soft key.
Using the headset:
1. With the headset connected, press
2. Enter the number, and then press the Call soft key.
Note:
During a call, you can alternate between the headset, hands-free speakerphone and handset modes by
pressing the HEADSET key, the Speakerphone key or by picking up the handset. Headset mode requires
a connected headset.

Answering a Call

If you are using the handset, pick up the handset.
If you are using the speakerphone, press
If you are using the headset, press
Note: You can reject an incoming call by pressing More->Reject.
Ending a Call
If you are using the handset, hang up the handset or press the EndCall soft key.
If you are using the speakerphone, press
If you are using the headset, press the EndCall soft key.
Redial
Press when the phone is idle to dial out the last dialed number.

Call Mute and Un-mute

Press to mute the microphone during a call.
Press again to un-mute the call.

Call Hold and Resume

To place a call on hold:
1. Press the Hold soft key during an active call. The first line key LED slowly flashes green.
To resume the call, do one of the following:
If there is only one call on hold, press the Resume soft key.
If there is more than one call on hold, press
press the Resume soft key .
.
to activate the headset mode.
.
.
or press the EndCall soft key.
or to select the call you want to resume, and then
4