Installation - ESAB LKA 180 Service Manual

INSTALLATION

S Place the machine in a suitable position and check that cooling is not obstructed.
S Check that the machine is connected to suit the
mains supply voltage. In the machines that can be
connected for different supply voltages, make the
appropriate connections as required at terminal
block XT3 and transformer TC1.
Make the necessary earth connections in accord-
ance with safety regulations.
S
Fit the filler wire as shown below.
The picture above is valid for machines with serial numbers before 618 ... ....
The picture above is valid from serial number 618 ... ....
If the drive rollers slip or wire feed does not work properly, it may be necessary to adjust the roller pressure, as
shown in Figure 5 above.
clka1de1
TC1
clka1p09
− 19 −
XT3
clka1p14