Installation And Connections; Shipping Bracket; Removing The Shipping Bracket (Refer To Figures 2-1 And 2-2) - Fujitsu ScanPartner 15C User Manual

2. INSTALLATION AND CONNECTIONS

Please unpack the Scanner carefully, and check the contents against the checklist. If
any items are missing or damaged, please contact your authorized local dealer
immediately.
Precautions
Keep the Scanner out of direct sunlight. Direct exposure to the sun or excessive
heat may cause damage to the unit.
Do not install the Scanner in a humid or dusty place.
Be sure to use the proper AC power source.
Place the Scanner securely on an even, flat surface. Tilted or uneven surfaces may
cause mechanical or paper-feeding problems.
Retain the Scanner box and packing materials for shipping purposes.

2.1 Shipping Bracket

The Scanner has a bracket that locks the carrier mechanism for transportation
purposes. This bracket must be put into the use position before using the Scanner.
If the power is turned on before the bracket has been removed the PAPER JAM light
will turn on. Before proceeding, turn the power off, disconnect all cables and follow
the instructions below to remove the shipping bracket.

2.1.1 Removing the Shipping Bracket (refer to figures 2-1 and 2-2)

i). Carefully place the Scanner in an upright position on its front.
ii). Using a suitable screwdriver, remove the screw and pull out the shipping
bracket.
iii). Put the shipping bracket into the use positions with the short side extending
into the Scanner base and secure it with the screw.
iv). Carefully place the Scanner back into its normal position.
2-1