Table of Contents
Advertisement
To avoid damaging the range, make sure that the connection data
(voltage and frequency) on the data plate correspond to the
building's power supply before connecting the appliance.
When in doubt, consult a qualified electrician.
Do not use a power strip or extension cord to connect the range
to electricity. These are a fire hazard and do not guarantee the
required level of appliance safety.
This appliance must not be installed and operated in mobile
installations (e.g. on a ship).
Danger of electric shock!
Under no circumstances open the outer casing of the appliance.
Do not repair or replace any part of the appliance unless
specifically recommended in the operating instructions. All other
servicing should be referred to a qualified technician.
Defective components should be replaced by Miele original parts
only. Only with these parts can safety of the appliance be assured as
intended by the manufacturer.
During installation, maintenance and repair work, e.g. if the oven
lighting is broken, the range must be completely disconnected from
the household electricity supply (see"Frequently asked questions").
The gas inlet valve must be closed. It is only completely isolated
from the supply when:
– The circuit breakers have been switched off, or
– the fuses of the electrical installation have been completely
removed, or
– the plug (if present) is removed from the socket. To do this, pull
the plug not the cord.
– Shut off the gas supply and disconnect the range from the gas
supply. Installation and maintenance of the gas connection must
be performed by qualified installers, service agencies or gas
providers.
IMPORTANT SAFETY INSTRUCTIONS
15
Advertisement
Table of Contents
