Miele HR19542DFG Operating Instructions Manual page 127

Problem
The oven lighting does
not turn on.
Frequently Asked Questions
Possible cause and solution
The halogen bulb needs to be replaced.

Danger of burns!
Make sure the heating elements are turned off and
allowed to cool completely.
The light cover consists of two seperate parts, a
glass cover and mounting. If it falls it can be
damaged.
When removing the cover hold it firmly so that it
does not fall. Place a towel on the oven floor and
open door to avoid damage.
 Disconnect the appliance from the power supply.
 Remove the screw to the lamp cover using a T20
Torx screwdriver, and take off the cover.
 Do not touch the halogen bulb with bare fingers.
Observe the manufacturers instructions.
Remove the halogen bulb.
 Replace it with a new halogen bulb (Sylvania
66740, 120 V, 40 W, G9, FS1). It must be thermally
stable up to 575°F (300°C).
 Replace the glass piece in the mounting, and refit
the lamp cover. Make sure that the lug on the
mounting is correctly located in the notch in the
roof of the oven, then screw the mounting back
into place.
 Reconnect the oven to the electrical supply.
127