Updating The Auxiliary Files; Table 7-1: Ini And Auxiliary Files Descriptions - AudioCodes MediaPack MP-11 Series Fast Track Manual

7.2

Updating the Auxiliary Files

The auxiliary files are configuration dat files that are loaded to the gateway (in addition to the ini
file) to enable enhanced gateway provisioning. The following common auxiliary files are available:
coefficient, Voice Prompts (MGCP only) and Call Progress Tones (CPT). For information on
additional auxiliary files, refer to the MediaPack User's Manual.
description of the ini file and of each auxiliary file.
File Type
Load this file to provision the device's parameters. The Embedded Web Server
Ini
enables practically full device provisioning but customers may occasionally require
new feature configuration parameters in which case this file is loaded.
Note that loading the ini file only provisions parameters that are contained in the ini
file. If a parameter is not specified in the ini file, values associated with that parameter
are reset to a default value. These values may not be the same as the values that
were configured for the VoIP gateway at the time of manufacture.
Note: After the file has completed loading, the VoIP gateway automatically restarts
(software is loaded from the flash).
This file contains the telephony interface configuration information for the VoIP
FXS Coefficient
gateway. This information includes telephony interface characteristics, such as DC
and AC impedance, feeding current and ringing voltage. This file is specific to the
type of telephony interface that the VoIP gateway supports. In most cases you have
to load this type of file.
Note: Use the parameter 'CountryCoefficients' (described in the MediaPack User's
Manual) to configure the FXO coefficients.
The voice announcement file contains a set of Voice Prompts to be played by the
Voice Prompts
MediaPack during operation on Call Agent request. Only MGCP is supported.
This is a region-specific, telephone exchange-dependent file that contains the Call
Call Progress
Progress Tones levels and frequencies that the VoIP gateway uses. Default CPT file:
Tones
U.S.A.
To load an auxiliary file via the Embedded Web Server, take these 6
steps:
Open the 'Auxiliary Files' screen (Software Update menu > Load Auxiliary Files); the
1.
'Auxiliary Files' screen is displayed (shown in
Click the Browse button that is in the field for the type of file you want to load.
2.
Navigate to the folder that contains the file you want to load.
3.
Click the file and click the Open button; the name and path of the file appear in the field next
4.
to the Browse button.
Click the Send File button adjacent to the field that contains the name of the file you want to
5.
load. An asterisk in the screen section indicates that the file's loading takes effect on-the-fly
(e.g., Voice Prompts file).
Repeat steps 2 to 5 for each file you want to load.
6.
Analog Fast Track Guide

Table 7-1: ini and Auxiliary Files Descriptions

34
Table 7-1
Description
Figure 7-8).
Document #: LTRT-59802
MediaPack
presents a brief