Notice To Users Of Radios And Television; Notice To Users Of The Us Telephone Network - Fujitsu Stylistic 3500 User Manual

Fujitsu stylistic 3500: user guide

Hide thumbs Also See for Stylistic 3500:

Table of Contents

Notice to Users of Radios and Television

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If the

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet that is on a different circuit than the

receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Shielded interconnect cables must be employed with this equipment to ensure

compliance with the pertinent RF emissions limits governing this device.

The Stylistic 3500 pen tablet is supplied with an internal modem which complies

with Part 68 of the FCC rules. On the pen tablet is a label that contains the FCC

Registration Number and Ringer Equivalence Number (REN) of this system, along

with other information. If requested, users must provide their telephone company

with the following information:

• The telephone number to which the pen tablet is connected

• The Ringer Equivalence Number (REN) for this equipment

• The information that the system requires a standard modular jack type USOC

RJ-11C which is FCC Part 68-compliant

• The FCC Registration Number

This equipment is designed to be connected to the telephone network or premises

wiring using a standard modular jack type USOC RJ-11C which is FCC Part

68-compliant.

The REN is used to determine the number of devices you may connect to your

telephone line and still have all those devices ring when your number is called.Too

many devices on one line may result in failure to ring in response to an incoming call.

Appendix

Table of Contents