Table of Contents
Advertisement
Gear Case Oil
1. Park the ATV on level ground.
2. Place an oil drain pan under the oil drain bolt (1).
3. Remove the oil fill cap (2), drain bolt and sealing washer (3).
4. After the oil has completely drained, reinstall the drain bolt with
the new sealing washer and tighten it to the specified torque:
9 lbf·ft (12 N·m , 1.2 kgf·m)
5. Pour the drained oil into a suitable container and dispose of it in
an approved manner (page 156).
NOTICE
Improper disposal of drained fluids is harmful to the environment.
6. Fill the gear case with the recommended oil.
2.7 US oz (80 cm
7. Remove the oil level check bolt (4) and sealing washer. Make sure
the oil level reaches the oil level check hole (5).
8. Install the oil fill cap.
9. Install the oil level check bolt with the new sealing washer and
tighten it to the specified torque:
9 lbf·ft (12 N·m , 1.2 kgf·m)
REAR
(5)
(4)
(1) oil drain bolt
(2) oil fill cap
(3) sealing washer
98
Servicing Your Honda
3
)
(2)
(3)
(3)
(1)
(4) oil level check bolt
(5) oil level check hole
Advertisement
Table of Contents
