Diagnosis And Service Service Menu; Checks ■ Calling Up The Service Menu; Exiting The Service Menu; Diagnosis - Viessmann VITODENS 100-W Installation And Service Instructions Manual

Diagnosis and service checks
Service menu
Calling up the service menu
Tap the following buttons:
1. and OK simultaneously for approx. 4 s, then
release.
2. Select the required menu section (e.g. "b.1" Con-
nect with software tool).
Note
Not all menu areas will be available, depending on
the system equipment level.
Service menu overview
Service
Er Active messages
b.1 Connect with software tool
b.2 System configuration
b.3 Diagnostics
d.1 Outside temperature
d.2 Heat generator flow temperature
d.4 Flue gas temperature
d.5 Burner hours run
d.6 Burner output
d.8 Serial number of heat generator
d.9 Heating circuit 1 flow temperature
b.4 Message history
b.5 Commissioning assistant
b.6 Start upper/lower heating output for test mode

Exiting the service menu

Tap the following buttons:
" " several times.

Diagnosis

Checking operating data

Operating data can be checked in various areas. See
"Diagnosis" in the service menu overview.
Operating data on heating circuits with mixer can only
be called up if such components are installed in the
system.
Note
If a called up sensor is faulty, "- - -" appears on the
display.
44
Note
Tap " " to return to the service menu.
Note
The system exits the service menu automatically
after 30 min.
Calling up operating data
Tap the following buttons:
1. and OK simultaneously for approx. 4 s, then
release.
2. Use / to select "b.3" for diagnostics.
3. OK