Technical Data; Preparing The Device For Exploitation; Requirements Concerning The Place Of Installation; Connection And Actuation - Igloo JAMAJKA W Series User Manual

2.3. Technical data

Table 1 Technical data

Rated volta-
Type of device
ge [V/Hz]
JAMAJKA W
1.3W * 230/50
1.3W-mod/A * 230/50
1.3W-mod/C * 230/50
0.9W * 230/50
0.9W-mod/A * 230/50
0.9W-mod/C * 230/50
0.6W * 230/50
0.6W-mod/A * 230/50
0.6W-mod/C * 230/50
MARTA W
1.3W 230/50
1.3W-mod/A 230/50
1.3W-mod/C 230/50
Depending on the version of the device "Jamajka W" apparatuses have wooden (*) or stainless casing. There are also
"RETRO" and "TREND" versions of wooden casings.
.

3. PREPARING THE DEVICE FOR EXPLOITATION

3.1. Requirements concerning the place of installation

• Verify whether the cross section of feeding conduits is proper for power consumption of the installed device.
• It is forbidden to connect the device by extension rods or dividers.
• The device should be connected to the separate, properly made electric circuit with plug-in socket with protecting pin
(according to PBUE /Regulations concerning Electric Equipment Construction/)
The device may be actuated solely after confi rmation of the fi re protection effi ciency with results of measu-
res performed according to binding regulations!

3.2. Connection and actuation

• Unpack the device and remove wooden platform
• The device should on an even and on a suffi ciently hard base, and then level it with the help of feet Fig.1/11 (p.13)
• Remove the protecting foil from display cabinet elements
• The fi rst cleaning of the device should be provide right after unpacking, and before turning it on. The unit should
be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning
the equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protecti-
ve layer and components of the device! Any residue of adhesives or silicone on metal elements should be remo-
ved only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.
When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.
• If the user shall obtain a device partially disassembled to secure it during transportation, perform the following ope-
rations:
1. (This concerns only "Jamajka" device) Fix hooks with fl uorescent lamp in the frame Fig.3 (p.15)
2. Fix glass shelves on the frame and on inner top Fig.5/2 (p.15)
3. Place trays (for cakes) on glass shelves
After installation of the device at the destination place it should be left to rest for at least 2 hours before
turning it on (for devices with built in compressor) to set the level of refrigerant in order to prevent problems
with starting up the aggregate.
WARNING: Keep out the cooling circuit from damage!
14
User manual Jamajka W, Marta W
Rated ligh-
Rated
ting power
current [A]
[W]
4,6 144
4,6 144
1,2 144
2,9 72
2,9 72
0,8 72
2,1 60
2,1 60
0,4 60
4,6 144
4,6 144
1,2 144
Electric
energy con- Shelf load
sumption [kg/mb]
[kWh/24h]
15,2 10
15,2 10
4,2 10
9,7 10
9,7 10
2,8 10
7,0 10
7,0 10
1,7 10
15,2 10
15,2 10
4,2 10
en
Cooling
Weight of
power
the device
requirement
[kg]
[W/mb]
- 200
- 174
600 154
- 150
- 129
600 114
- 100
- 74
600 64
- 250
- 224
600 204
www.igloo.pl