Maintenance; Cleaning And Maintenance; Fig.8 Assembly Of The Fronmt Glass; Fig.9 Cleaning The Condenser - Igloo BASIA M User Manual

5. MAINTENANCE

5.1. Cleaning and maintenance

All maintenance services need to be performed after disconnecting the device from power supply!
Protect electric installation against any damage or water spillage
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove dirt!
Devices with wheels cannot be used on uneven surfaces!
When cleaning the interior of the device, it is forbidden to leave the front glass freely lifted in the aluminium profile.
This may result in the damage of the glass and is not covered by warranty. Remove the glass with the profile for the
period of maintenance Fig.8 (p.16).
1 2
It is recommended to make a break in the exploitation of the device once a month in order to clean its interior and
naturally defrost the evaporator and clean the condenser.
Do not use mechanical agents to fasten the defrosting process!
It is essential to keep the condenser of the device cle-
an. Dirt may hinder the heat exchange, causing mainly
increase in electric energy consumption and may cause
damage of aggregate compressor.
In order to clean the condenser it is necessary to
unscrew metal screws and pull the wind brace. Clean
condenser lamellas with help of soft brush or paintbrush.
If the condenser is extremely dirty (blocked lamellas) it
is indicated to use vacuum cleaner or compressed nitro-
gen to suck / blow the dirt from between lamellas.
The producer shall not be held responsible for damages of the condenser aggregate resulting from non-
observance of condenser cleanliness!
16
User manual BASIA M
3
Fig.8 Disassembly of the front glass
1- Front glass
2- Upper aluminium profile (lifted guide) of the glass
3- Lower aluminium profile (hinge) of the glass

Fig.9 Cleaning the condenser

en
www.igloo.pl