Technical Data; Preparing The Device For Exploitation; Requirements Concerning The Place Of Installation; Connection And Actuation - Igloo JAMAJKA Series User Manual

2.3. Technical data

Table 1. Technical data
Type of device
JAMAJKA G 1.3
JAMAJKA G 1.3 RETRO
JAMAJKA G 1.3 TREND
JAMAJKA G 0.9
JAMAJKA G 0.9 RETRO
JAMAJKA G 0.9 TREND
JAMAJKA G 0.6
JAMAJKA G 0.6 RETRO
JAMAJKA G 0.6 TREND
Depending on the version of the device Jamajka Heated apparatuses have wooden (*) or stainless casing.

3. PREPARING THE DEVICE FOR EXPLOITATION

3.1. Requirements concerning the place of installation

• Verify whether the cross-section of feeding conduits is proper for the power consumption of the installed device
• It is forbidden to connect the device by means of extension cords or dividers
• The device should be connected to the separate, properly made electric circuit with plug-in socket with protecting pin
(according to PBUE /Regulations concerning Electric Equipment Construction/)
The device may be actuated solely after confi rmation of the fi re protection effi ciency with results of measu-
res performed according to binding regulations!

3.2. Connection and actuation

• Unpack the device and remove wooden platform Fig.3 (p.10)
• Place the display cabinet on an even basis, which is hard enough, and then level it with feet.
• The fi rst cleaning of the device should be provide right after unpacking, and before turning it on. The unit should
be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning
the equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protecti-
ve layer and components of the device! Any residue of adhesives or silicone on metal elements should be remo-
ved only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.
When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.
• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means of
extension cords or dividers!)
• Turn on the main switch Fig.4/1 (p.11), which will cause the start up of the heated device and lighting up red or green light.
• Use the control knob Fig.4/5 (p.11) to set the desired temperature inside the unit.
• Place the condensate reservoir under water outfl ow elements located under display cabinet frame Fig.5 (p.12)
• Check whether the water outfl ow ball valve is closed Fig.2/10 (p.9)
• Connect lighting switch Fig.4/2 (p.11)

Fig.3 Removing the wooden platform

1. Unscrew the feet from the platform
2. Remove the wooden platform
3. Screw the feet into nuts welded to the frame of the device
10
User manual Jamajka G
Rated volta- Rated cur-
ge [V/Hz] rent [A]
230/50 9.0
230/50 9.0
230/50 9.0
230/50 7.2
230/50 7.2
230/50 7.2
230/50 3.6
230/50 3.6
230/50 3.6
1 2
Rated lighting Electric energy con-
power [W] sumption [kWh/1h]
200 0.7
200 0.7
200 0.7
200 0.6
200 0.6
200 0.6
200 0.3
200 0.3
200 0.3
3
en
Shelf load Weight
[kg/mb] [kg]
10 195*
10 195
10 200
10 145*
10 145
10 148
10 90*
10 90
10 93
www.igloo.pl