Table of Contents
Advertisement
RX-E200
* : Execution of FACTORY PRESET (Refer to page 7.) will facilitate setting reception frequency for adjustment.
Step
Adjustment item
1
Adjustment of
discriminator balance
2
Verification of monau-
ral distortion
3
Verification of stereo
distortion
4
Verification of sensi-
tivity
5
Verification of
Separation
6
Verification of auto
tuning
9
Reception
Signal (ANT IN)
frequency
FM ANT (75Ω)
98.1MHz
98.1MHz ± 5kHz
* (A-1)
70dBµ
MONO
1kHz,
100% modulation
98.1MHz
FM ANT (75Ω)
* (A-1)
98.1MHz
70dBµ
MONO 1kHz,
100% modulation
FM ANT (75Ω)
98.1MHz
* (A-1)
98.1MHz
Tuning mode
70dBµ
should be
Stereo L or R
1kHz,
AUTO.
100% modulation
88.1MHz
FM ANT (75Ω)
88.1MHz
* (A-6)
98.1MHz
98.1MHz
* (A-1)
106.1MHz
106.1MHz
MONO 1kHz
Modulation off
* (A-7)
98.1MHz
FM ANT (75Ω)
* (A-1)
98.1MHz
70dBµ
Stereo L or R
1kHz,
100% modulation
98.1MHz
FM ANT (75Ω)
98.1MHz
23dBµ
Stereo L or R
1kHz,
30% modulation
Adjusted
Test point
point
L10
Both ends of R24
(Between pin 26
and pin 28 of IC1)
REC OUT L, R
REC OUT L, R
ANT (75Ω)
REC OUT L, R
Rating
DC 0V±50mV
– 36dB or less
– 29dB or less
• STEREO indicator should
light.
1) Set the tuning mode to
MAN'L MONO. (Muting OFF)
2) S/N should be 30dB at each
frequency of 88.1MHz,
98.1MHz, and 106.1MHz.
3) Check to ensure that the volt-
age at the ANT terminal is
6dBµ (14.25dBf) or less.
(A, B, G only : 10dBµ or less)
22dB or more
• Automatic reception
should be available when
the tuning key is moved UP
and DOWN.
• The stereo indicator should
light.
• Audio muting should be ap-
plied during tuning.
Advertisement
Table of Contents
