Memory Upgrade Module - Fujitsu Lifebook E342 Manual

MEMORY UPGRADE MODULE

Your notebook has 32MB or 64MB of on-board
SDRAM. To increase your memory capacity
you may install a memory upgrade module in
the memory upgrade compartment in the bot-
tom of your notebook. The memory upgrade
module is a Small Outline dual-in-line memory
module (SODIMM). You may add modules of
different capacity.
C A U T I O N
Never remove screws except the ones
specifically shown in the directions for
installing and removing the memory
upgrade module.
U s e r I n s t a l l a b l e
To Install a Memory Upgrade Module:
1. Turn off power to your notebook using
the power switch, (see Power Off on pages
24-25), and remove any power adapter
(AC or auto/airline).
2. Make sure that all the connector covers
are closed.
3. Turn the notebook bottom side up, with the
front panel toward you.
4. Remove the screws at the front of the
memory upgrade module compartment.
(See Figure 5-12.)
5. Remove the cover by tilting the front edge
up and then pulling forward until the tabs
on the cover are free. (See Figure 5-12.)
6. Remove the memory upgrade module from
the static guarded sleeve.
L i f e B o o k E S e r i e s f r o m F u j i t s u
F e a t u r e s
C A U T I O N
The memory upgrade module can be
severely damaged by electro-static dis-
charge (ESD). Be sure you are properly
grounded when handling and installing
the module.
Figure 5-12 Opening the Memory Upgrade Compartment
141