Fujitsu Lifebook E342 Manual page 137

S e c t i o n F i v e
Lithium ion battery installed with Battery
Adapter for Multi-function Bay 2.
(Adapter included with your Battery.)
Weight Saver.
The Lithium ion battery included with your
notebook can power your notebook from either
bay. Your notebook also supports a dual battery
configuration with a Lithium ion battery in
both bays at the same time. (The optional
second battery must be purchased separately.)
C A U T I O N
The LifeBook E Series notebook does not
support multiple floppy disk drives, but
has two different places to install one.
130
C A U T I O N
Be careful aligning and seating modules
in the bay. If the fit is incorrect you may
damage the bay or the module. If the
module does not move easily, remove
it, and check for dirt or foreign objects.
It will require a firm push to latch the
module in place.
Removing a Device in Multi-function
Bay 1 or 2 When the System is Off.
1. Close any open files on the removable device
that you plan to eject from the computer, if a
device is currently installed and shut down.
2. Slide the release latch at the left rear corner of
the Multi-function Bay toward the outer edge
of your notebook.
3. Slide the device forward until the unit is clear
of the compartment. This will require some
force. Use the finger ridge on the bottom of
the device.
Figure 5-2 Removing and Installing a
Device in Multi-function Bay 1
Installing a Device in Multi-function
Bay 1 or 2 When the System is Off.
1. Orient the item to be installed with the finger
ridge away from the body of your notebook
and the connector toward the body of
your notebook.
2. With the module connector toward the back
of your notebook align the grooves on the
side of the device with the tracks in the side
of the bay. (Figure 5-3.)