Fujitsu Lifebook E342 Manual page 150

4. Store the memory upgrade module in a
static guarded sleeve.
5. Replace the cover by following the instructions
in steps 10 and 11 of the instructions for To
Install a Memory Upgrade Module, or install
a new memory upgrade module and then
replace the cover by following the instructions
in steps 7 through 11 of the instructions
To Install a Memory Upgrade Module.
C A U T I O N
The memory upgrade module can
be severely damaged by electro-static
discharge (ESD). Be sure you are properly
grounded when handling and removing
the module.
U s e r I n s t a l l a b l e
Checking the Computer
Recognition of New Memory Capacity
When you have changed system memory capac-
ity by adding or removing a memory upgrade
module, be sure to check that your notebook
has recognized all of the memory. You can
check memory capacity by looking at the Main
menu of the setup utility:
1. Turn on power using the power switch.
2. Enter the setup utility by pressing the F2
key as soon as the Fujitsu logo appears
on the screen.
3. The System Memory and the Extended
Memory capacity, as detected by your note-
book during the Power On Self Test (POST),
are displayed at the bottom of the Main
menu screen.
L i f e B o o k E S e r i e s f r o m F u j i t s u
F e a t u r e s
Example: A system with 32MB of memory
will display 640K System Memory, 31MB
Extended Memory.
When you have installed additional memory,
the display should change. For example for:
Total RAM
Installed
32 MB
48 MB
64 MB
96 MB
128 MB
160 MB
192 MB
If the total memory displayed is not what you
believe it should be, check that your memory
upgrade module is properly installed. If it is
properly installed and the capacity is not cor-
rectly recognized, see the Troubleshooting
Section starting on page 150.
System Extended
Memory Memory
640 K 31 MB
640 K 47 MB
640 K 63 MB
640 K 95 MB
640 K 127 MB
640 K 159 MB
640 K 191 MB
143