Advertisement
3.1 Troubleshooting Guide
BitRunner V2 will
not turn on.
BitRunner V2
stopped working
suddenly.
Troubleshooting and Maintenance
BitRunner V2 is not enabled
BitRunner V2 is not plugged into power.
Cables are not correctly plugged in.
The fuse may have blown if:
• You know the G-code is good
• Control pendant LED still lights up.
The fuse can blow if the router shorts or
if there is a short in your home.
support@carbide3d.com
Press the control pendant button
to enable the BitRunner V2.
Ensure BitRunner V2 is plugged
into a power outlet.
Ensure all cables are correctly
connected. In particular, check
correct connection of the logic
cable at the Shapeoko controller.
Replace the old fuse with a new
15A 250V 5×20mm fuse. See
Replacing the Fuse
docs.carbide3d.com
below.
08/19/2021
v1.0
13
Advertisement
Need help?
Do you have a question about the BitRunner V2 and is the answer not in the manual?
Questions and answers