Carbide 3D BitRunner V2 Quick Start Manual page 10

2.1 Enable/Disable the BitRunner V2
The BitRunner V2 is enabled and disabled via the control pendant.
To enable the BitRunner V2:
1. Press the control pendant button to supply power to the router. The red button LED will turn ON. See
Figure 8.
Figure 8
To disable the BitRunner V2:
2. Press the control pendant button again to cut power to the router. The button LED will turn OFF.
Using the BitRunner V2
support@carbide3d.com docs.carbide3d.com
08/19/2021 v1.0
10