Table of Contents
Advertisement
INTERNAL CLEANING
•
Carefully clean the appliance, including the
rubber gasket of the door, with a soft damp
cloth.
•
If you regularly use short duration programmes,
these can leave deposits of grease and
limescale inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per month.
TROUBLESHOOTING
If the appliance does not start or it stops during
operation, before you contact an Authorised
Service Centre, check if you can solve the problem
by yourself with the help of the information in the
table.
WARNING! Repairs not properly
done may result in serious risk to the
safety of the user. Any repairs must be
performed by qualified personnel.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
•
The end indicator flashes 1 time inter-
mittently.
•
The
indicator flashes continuously.
The appliance does not drain the water.
•
The end indicator flashes 2 times inter-
mittently.
•
The
indicator flashes continuously.
16
•
To maintain the performance of your appliance
at its best, we recommend to use monthly a
specific cleaning product for dishwashers.
Follow carefully the instructions on the
packaging of the product.
With some problems the end indicator flashes
intermittently indicating a malfunction.
The majority of problems that can occur can
be solved without the need to contact an
Authorised Service Centre.
Possible cause and solution
•
Make sure that the mains plug is connected to the
mains socket.
•
Make sure that there is no damaged fuse in the fuse
box.
•
Make sure that the appliance door is closed.
•
Press
.
•
If the delay start is set, cancel the setting or wait for
the end of the countdown.
•
The appliance has started the procedure to re-
charge the resin inside the water softener. The dura-
tion of the procedure is approximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clog-
ged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or
bends.
Advertisement
Table of Contents
