Zanussi ZDF221 User Manual
Hide thumbs Also See for ZDF221:


Quick Links

User manual


Table of Contents

Summary of Contents for Zanussi ZDF221

  • Page 1 User manual Dishwasher ZDF221...
  • Page 2: Table Of Contents

    Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.
  • Page 3: Safety Information

    Safety information In the interest of your safety and to ensure the ried out by inexperienced persons will cause correct use, before installing and first using the injury or serious malfunctioning. Contact appliance, read this user manual carefully, in- your local Service Force Centre. Always in- cluding its hints and warnings.
  • Page 4: Control Panel

    Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine.
  • Page 5 Programme selector dial and On/Off switch • when in this position, the machine is switched off (corresponding light off), • when the marker on the dial corresponds with a programme, the machine is switched on and a pro- gramme is selected (programme selector indicator light on) Start/cancel button •...
  • Page 6: Washing Programmes

    Indicator lights End of programme indicator light Illuminates when the washing programme has ended. Switch off the dishwasher by returning the programme selector dial to the Off position. The On/Off indicator light turns off. It also has added functions of visual signalling as: –...
  • Page 7: First Use

    Programme Degree of soil Type of load Programme description Any. 1 cold rinse (to avoid food Rinse and Hold Partial load (to be completed later in the day). scraps from sticking together). This programme does not require the use of deter- gent.
  • Page 8: Set The Water Softener

    – Adjust the rinse aid dosage Set the water softener The dishwasher is equipped with a water grees (°dH), French degrees (°TH) and mmol/ softener designed to remove minerals and salts l (millimol per litre - international unit for the from the water supply, which would have a det- hardness of water).
  • Page 9: Filling With Dishwasher Salt

    Setting the water softener manually (see table) The water softener is factory set at position 2. Set switch to position 1 or Setting the water softener electronically (see table) The water softener is factory set at position 5. The dishwasher must be switched off . Release the button.
  • Page 10 Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. ter. IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added.
  • Page 11: Filling With Rinse Aid

    Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close indicated by "max" the lid and press until it locks. IMPORTANT! CAUTION! Top up the rinse aid when the light on the control panel Never fill the rinse aid dispenser with any other sub- illuminates.
  • Page 12: Loading Cutlery And Dishes

    Loading cutlery and dishes – Dishes and items of cutlery must not lie Sponges, household cloths and any object that inside one another, or cover each other. can absorb water may not be washed in the – To avoid damage to glasses, they must dishwasher.
  • Page 13 Load cutlery. For best re- Place knives and other Load the lower basket. Arrange serving dishes and sults we recommend you items of cutlery with sharp large lids around the edge of the basket. to use the cutlery grid pro- points or edges with their vided (if the size and di- handles facing upwards.
  • Page 14: Use Of Detergent

    To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mecha- nism is engaged and the basket is stable. To lower the basket to the original position proceed as follows: 1.
  • Page 15: Unloading The Dishwasher

    For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in com- tablets in compartment A. partmentB. Unloading the dishwasher • Hot dishes are sensitive to knocks. • Water may appear on the sides and the door The dishes should therefore be allowed to of the dishwasher as the stainless steel will cool down before removing from the appli-...
  • Page 16 Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing com- water. move filters B and C. partment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle...
  • Page 17: Environmental Concerns

    2. Leave the door ajar to prevent the forma- 1. Unplug it. tion of any unpleasant smells. 2. Turn the water tap off. 3. Leave the inside of the machine clean. 3. Remove the water inlet and discharge ho- ses. Frost precautions 4.
  • Page 18: Something Not Working

    Something not working The dishwasher will not start or stops during Switch off the dishwasher, open the door and operation. carry out the following suggested corrective ac- Certain problems are due to the lack of simple tions. maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
  • Page 19 Once these checks have been carried out; This information can be found on the rating close the dishwasher’s door and switch on the plate located on the side of the dishwasher appliance. Press the button of the programme door. that was running before the intervention of the So that you always have these numbers at hand, we recommend you to make a note of alarm.
  • Page 20: Technical Data

    Technical data Dimensions Width x Height x Depth 60,0 x 85,0x 61,0 Electrical connection Information on the electrical connection is given on the rating plate on the Voltage - Overall power - Fuse inner edge of the dishwasher’s door. Water supply pressure Minimum - Maximum 0,05 - 0,8 (MPa)
  • Page 21: Hints For Test Institutes

    Hints for test institutes Testing in accordance with EN 60704 must be aid dispenser have been filled with salt and carried out with appliance fully loaded and us- rinse aid respectively and using the test pro- ing the test programme (see "Consumption gramme (see "Consumption values").
  • Page 22 Water connection CAUTION! If the machine is connected to new pipes or WARNING! pipes which have not been used for a long time, The dishwasher must not be connected to open you should run the water for a few minutes be- water appliances or instantaneous water heat- fore connecting the inlet hose.
  • Page 23 Drain hose Connect drain hose to the Required height: 30 to 100 Ensure that the hoses are When connecting the sink. Secure it with the cm above bottom of the not kinked, crushed or en- drain hose to an under supplied hose clamp.
  • Page 24 Fitting under a counter Be sure that once the appliance has been in- stalled, it is easily accessible for the service By removing the dishwasher’s worktop, you can engineer in the event that a repair is required. install it under a close fitting sink unit or a pre- existing top.
  • Page 28 156994660-00-16072007 Subject to change without notice...

Table of Contents