Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.
Safety information • Under no circumstances should you attempt In the interest of your safety and to ensure the to repair the machine yourself. Repairs car- correct use, before installing and first using the ried out by inexperienced persons will cause appliance, read this user manual carefully, in- injury or serious malfunctioning.
Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine.
Page 5
Programme selector dial and On/Off switch • when in this position, the machine is switched off (corresponding light off), • when the marker on the dial corresponds with a programme, the machine is switched on and a pro- gramme is selected (programme selector indicator light on) Start/cancel button •...
Indicator lights Wash indicator light Illuminates when a washing programme is set and re- mains illuminated for all the duration of the washing programme. Turns off when the washing programme has ended. End of programme Illuminates when the washing programme has ended. Switch off the dishwasher by returning the programme selector dial to the Off position.
Programme Degree of soil Type of load Programme description Bio 50° Normal soil Crockery and cutlery Prewash Main wash 1 intermediate rinse Final rinse Drying Rinse and Hold Any. 1 cold rinse (to avoid food Partial load (to be completed later in the day). scraps from sticking together).
If you decide in future to use separated deter- – Adjust the water hardness setting according gents, we advise that you: to the hardness of the water in your area. – Fill up the salt and rinse aid container. – Adjust the rinse aid dosage –...
Setting the water softener manually (see table) The water softener is factory set at position 2. Set switch to position 1 or Setting the water softener electronically (see table) The water softener is factory set at position 5. The dishwasher must be switched off . Release the button.
Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. ter. IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added.
Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close indicated by "max" the lid and press until it locks. IMPORTANT! CAUTION! Top up the rinse aid when the light on the control panel Never fill the rinse aid dispenser with any other sub- illuminates.
Loading cutlery and dishes – Dishes and items of cutlery must not lie Sponges, household cloths and any object that inside one another, or cover each other. can absorb water may not be washed in the – To avoid damage to glasses, they must dishwasher.
Load cutlery. For best re- Place knives and other Load the lower basket. Arrange serving dishes and sults we recommend you items of cutlery with sharp large lids around the edge of the basket. to use the cutlery grid pro- points or edges with their vided (if the size and di- handles facing upwards.
To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mecha- nism is engaged and the basket is stable. To lower the basket to the original position proceed as follows: 1.
For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in com- tablets in compartment A. partmentB. Unloading the dishwasher • Hot dishes are sensitive to knocks. • Water may appear on the sides and the door The dishes should therefore be allowed to of the dishwasher as the stainless steel will cool down before removing from the appli-...
Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing com- water. move filters B and C. partment. Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle...
2. Leave the door ajar to prevent the forma- 1. Unplug it. tion of any unpleasant smells. 2. Turn the water tap off. 3. Leave the inside of the machine clean. 3. Remove the water inlet and discharge ho- ses. Frost precautions 4.
Something not working The dishwasher will not start or stops during Switch off the dishwasher, open the door and operation. carry out the following suggested corrective ac- Certain problems are due to the lack of simple tions. maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
Page 19
Once these checks have been carried out; This information can be found on the rating close the dishwasher’s door and switch on the plate located on the side of the dishwasher appliance. Press the button of the programme door. that was running before the intervention of the So that you always have these numbers at hand, we recommend you to make a note of alarm.
Technical data Dimensions Width x Height x Depth (cm) 60,0 x 85,0 x 61,0 Electrical connection Information on the electrical connection is given on the rating plate on the Voltage - Overall power - Fuse inner edge of the dishwasher’s door. Water supply pressure Minimum - Maximum 0,05 - 0,8...
Test in accordance with EN 50242 must be rinse aid respectively and using the test pro- carried out when the salt container and rinse gramme (see "Consumption values"). aid dispenser have been filled with salt and Full load: 12 standard place settings Amount of detergent required 5 g + 25 g (Type B) Rinse aid setting...
you should run the water for a few minutes be- WARNING! fore connecting the inlet hose. Only use, for connection to the water mains, new hose-set; old hose-set must not be reused. CAUTION! If the machine is connected to new pipes or pipes which have not been used for a long time, Inlet hose Connect the inlet hose to a water tap with an external...
If you use a drain hose extension the total This could constitute a fire hazard through over- length should not be longer than 4 metres. heating. Likewise the internal diameter of the couplings If necessary, have the domestic wiring system used for connections to the waste outlet must socket replaced.
Levelling Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on either side of the cabinet. Guarantee/Customer Service use for professional or equivalent purpo- Belgium ses. DECLARATION OF GUARANTEE TERMS.
Page 25
The statutory warranty does not apply disproportionate, in agreement with the when defects are caused by: consumer, the defective appliance may be replaced with another appliance of the – a chemical or electrochemical reaction same value. In this event, we reserve the caused by water, right to ask for a financial contribution cal- –...