Table of Contents
Advertisement
Choosing The Right Location
Recommend Installation
准。
Energy Rating Information
The energy rating and noise information for this unit is based on the standard installation using an un-extended
exhaust duct (Diameter:150mm, Length:1.5m) without window slider adaptor or wall exhaust adaptor A.
The unit with 3 meters extended exhaust duct is running by using 2 exhaust ducts(Diameter:150mm, Length:1.5m
+ Diameter: 130mm, Length: 1.5m) .The Energy rating and noise information for unit with 3 meters extended
exhaust duct is not assessed.(For some models)
NOTE：
We recommend that operating the unit at room temperature below
meters extended exhaust duct would not work at room temperature above
such as the lower air intake be blocked for 50%.
Your installation location should meet the following requirements:
-Make sure that you install your unit on an even surface to minimize noise and
vibration.
-The unit must be installed near a grounded plug, and the Collection Tray Drain
(found on the back of the unit) must be accessible.
-The unit should be located at least 30cm (12") from the nearest wall to ensure
proper air conditioning. The horizontal louver blade should be at least 50cm
(19.7") away from obstacles.
-DO NOT cover the Intakes, Outlets or Remote Signal Receptor of the unit, as this
could cause damage to the unit.
35°C
. Since there is a risk that the unit with 3
35°C
under some extreme conditions,
Page 7
Advertisement
Table of Contents
