Table of Contents
Advertisement
Troubleshooting
Troubleshooting
For information on troubleshooting a Reactor, refer to
the Reactor repair manual.
Problem
No module status LEDs are
illuminated.
No network connection.
Network is connected, but there is no
server connection.
14
Disconnect Cellular Module
NOTE: Before troubleshooting the Reactor, disconnect
the cellular module (A). The Reactor Connect cannot
change Reactor 2 settings while the cellular module is
disconnected.
1. Shut down system. See your Reactor 2 operation
2. Disconnect incoming power at the source.
3. Disconnect the cellular module CAN cable (D) from
Cause
No power to cellular module.
Still establishing cellular connection.
Unable to establish cellular
connection.
Cellular module software is incorrect. Go to ADM Advanced Software
Server is not responding.
manual for shutdown instructions.
the cellular module (A).
Turn Reactor proportioner on.
Ensure cellular module is properly
installed. See Installation, page 9.
Wait a few minutes for the unit to
establish a connection.
To establish cellular connection, move
system to a location with cellular
service.
Mount accessory antenna 25D878 on
the outside of your trailer.
screen and confirm that software is
correct. If it is not, update the ADM
software.
Wait a few minutes for the unit to
establish a connection.
Solution
3A5540D
Advertisement
Table of Contents
