Table of Contents
Advertisement
7. Using Factory default provisioning
7.1. Factory default #1 : <Limited AP & Web configuration>
7.1.1.
Changing mode to <Limited AP & Web mode>
If you click the <Reserved Button>(GPIO21
WizFi210 is restored to factory default setting and changed to <AP & Web mode>.
Figure 8 Button corresponding to that pin in WizFi210 Evaluation board
The IP address of WizFi210 is shown below.
IP:192.168.1.1
Subnet:255.255.255.0
Gateway:192.168.1.1
S the URL address of Wizfi210 is
Instead of clicking the <Reserved Button>, you can use the <AT Command> as below.
AT+XDUM=0
(Sent AT command followed 0x0d)
[OK]
AT+XCONFIG=1
(AT command echoed back by WizFi210)
APP Reset-APP SW Reset
Factory Default, Limited AP and WEB Daemon start
(Response which means executed successfully)
[OK]
IP
SubNet
192.168.1.1: 255.255.255.0: 192.168.1.1
[OK]
Figure 9 Example of using AT command instead of Hardware pin
12
User can do this using GPIO of Host processor, In order to know its timing information, refer to
Datasheet of WizFi210.
WizFi210
Programmers' Guide
12
or GPIO10) button twice consecutively, the
http://192.168.1.1
Gateway
(WIZnet Co., Ltd.)
7-51
Advertisement
Table of Contents
