Network Interface - Wiznet WizFi210 Programmer's Manual

Response
Table 7 List of commands for Wireless(RF) configuration
2.1.7.

Network interface

This category is for commands related to Network information setting.
Command Category
AT+NDHCP Format
Meaning
Response
AT+DHCPSR Format
VR
Meaning
Response
AT+NSET Format
Meaning
Response
AT+DNSLOO Format
KUP
Meaning
Response
AT+DNSSET Format
Meaning
Response
AT+STOREN Format
WCONN
Meaning
WizFi210 Programmers' Guide
the time of Association done after the command is issued.
[OK]
n
AT+NDHCP=
n =0 (DHCP mode disable)
n
=1 (DHCP mode enable)
If DHCP mode is disabled, Users have to use "AT+NSET=..." command
to set the adapter's static network information.
[OK]
n
AT+DHCPSRVR=
n
=0 (DHCP Server disable)
n
=1 (DHCP Server enable)
Prior to start the DHCP server, the adapter should be configured with
a valid static ip address using "AT+NSET=..."
[OK]
AT+NSET=
<Src Address>,<Net-mask>,<Gateway>
<Src Address>,<Net-mask>,<Gateway>
Set static network information; overrides previous values.
192.168.3.100,255.255.255.0,192.168.3.1
ex) AT+NSET=
[OK]
AT+DNSLOOKUP
= <URL>,[<retry>,[<timeout=S>]
<URL>,[<retry>,[<timeout=S>]
Query DNS server for address of hostname URL
google.com
Ex) AT+DNSLOOKUP=
[OK]
AT+DNSSET=
<DNS1 IP>,[<DNS2 IP>]
<DNS1 IP>,[<DNS2 IP>]
Set the DNS server addresses to be used.
Ex) AT+DNSSET= 192.168.3.1
[OK]
AT+STORENWCONN
Store network connection parameters prior to transition to Standby
(WIZnet Co., Ltd.)
Description
2-15