Wiznet WizFi210 Programmer's Manual page 33

AT+SETTIME Format
Meaning
Response
AT+GETTIME Format
Meaning
Response
AT+DGPIO Format
Meaning
Response
AT+XGPIO Format
Meaning
Response
AT+PING
Format
Meaning
WizFi210 Programmers' Guide
<dd/mm/yyyy>,<HH:MM:SS>
AT+SETTIME=
Set the adaptor system time
<dd/mm/yyyy>
: Date
<HH:MM:SS>
: Time
ex) AT+SETTIME=11/04/2013,09:00:00
[OK]
AT+ GETTIME= ?
Upon reception of this command the adaptor sends the current
system time in milliseconds since
epoch(1970) to the serial interface. The time format comes on the
serial interface as follows:
[OK]
AT+DGPIO= <GPIO-NO>,<SET/RESET(0/1)>
Set or reset (high/low) a GPIO pin
<GPIO-NO> : GPIO number
<SET/RESET(0/1)>
: GPIO value to set
ex) AT+DGPIO=31,0
[OK]
AT+XGPIO=<GPIO-NO>
Get a GPIO pin status(high/low).
GPIO-No is High or GPIO-No is Low.
<IP>,[[Trails],[<Interval>],[<Len>],[<TOS>],[<TTL>],[<PA
AT+PING=
YLOAD>]]
PING the IP address provided. Trails = 0 will ping until <Esc> C is
issued.
<IP>
: Target's IP address
<Trails>
: Option
<Interval>
: Option
<Len> : Option
<TOS> : Option
<TTL>
: Option
<PAYLOAD>
: Option
Ex) AT+PING=192.168.3.1,5
(WIZnet Co., Ltd.)
.
2-26