Starting the Mobile Computer
When the mobile computer is powered on for the first time, it initializes. The Symbol Splash screen appears for a short period of time,
followed by the Calibration screen.
After the calibration procedure is performed the factory settings launch the Demo window. Application specific shells may provide
application specific windows instead of the Demo window. These screens also appear when a cold boot is performed.
If the mobile computer does not power on, see
Calibration Screen
Use the Calibration screen to align the touch screen:
1. Remove the stylus from the stylus holder.
2. Carefully press and briefly hold the stylus tip on the center of the Calibration screen target. Repeat the procedure as the
target moves and stops at different locations on the screen. This enters the new calibration settings.
3. Once all of the new calibration settings are input, tap the screen or press the ENTER button to save the new calibration
settings. Press ESC to discard the new calibration settings.
Demo Window
The Demo window is the factory default menu. On initial power up (or on a warm or cold boot) the Demo window appears. These
sample/demo applications are intended to be used by application developers as application development examples. These
Figure 1-7. Symbol Splash Screen
Resetting the Mobile Computer on page
Calibration Screen
Figure 1-8. Calibration Screen
2-23.
Confirm Calibration Resave
Screen
Getting Started 1-11