Advertisement
Preparation for the BKS-R3210
You may use up to 253 units of the control unit,
including the BKS-R3210, in combination to expand
the number of sources and destinations, or use the unit
alone. The required settings may differ depending on
whether it is used alone or in combination. Make the
necessary settings shown below to fit your system.
When multiple BKS-R3210s are used in combination,
define one as the mother unit, and the others as
daughter units.
Setting the station number
Set the station number using the STATION ID switch
on the rear panel. The station number is obtained by
adding the binary place values of the switches that are
set to ON.
STATION ID
1 2 3 4 5 6 7 8
1
4
16
64
2
8
32
128
Set Station number: 1+2+8=11
Examples of setting a station number
ON
OFF
← These are the binary place
values of the switches.
Key label indications
It is recommended to write the source, destination or
level name on the key label on top of the source/
destination select buttons. Then you can see at a
glance what functions you have assigned to each
button.
Attaching a key label
The key labels are supplied with this control unit.
Attach the labels to the buttons with the following
procedure.
1
2
Key-top puller
3
Attaching a key label
1
Write the name on the supplied key label.
2
Remove the key top using the supplied key-top
puller.
3
Put the key label on the button and replace the key
top.
V T
R 1
2
V T
R 1
2
Key label
Key top
13 (E)
Advertisement
Chapters
