Table of Contents
Advertisement
5. Press and hold the
finishes scrolling, to turn OFF the Parent Unit.
NOTE
The battery icon
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 12 hours to charge fully.
When charging
1. During power OFF, when the power adapter is plugged in, a power
adapter icon will display on the screen and then a flashing battery icon will
display for 45 seconds. The Blue LED at the top left corner lights up to
indicate that the power adapter is plugged in.
2. During power ON, when the power adapter is plugged in, the battery icon
on the top right corner of the screen will show that the battery is charging.
The Blue LED at the top left corner lights up to indicate that the power
adapter is plugged in.
2.4
Registration (Pairing)
The Baby Unit is pre-registered to your Parent Unit. You do not need to register it again
unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure below:
M
1. Press the
button of the Parent Unit and the menu bar will pop up.
<
2. Press the
LEFT button or
The
+
3. Press the
UP button or
O button to confirm.
+
4. Press the
UP button or
and press the O button to start searching for a camera unit. The green
audio level LED will flash rapidly while searching.
5. Press the O button to confirm.
6. Press and hold the PAIR button underneath the Baby Unit until the Parent
Unit finds the camera, beeps and the video from the camera appears.
NOTE
If a particular Baby Unit was registered previously, registering this current Baby
Unit again will overwrite the old registration.
Getting Started
P
POWER ON/OFF button until the progress bar
turns RED to indicate that the battery is low, and it emits
>
RIGHT button until
menu will pop up.
-
DOWN button to select add, and press the
will pop up.
-
DOWN button to select the desired Camera
is highlighted.
11
Advertisement
Table of Contents
