Installation - Pentair ONGA IMH750 Owner's Manual

Installation

The electrical installation shall be in accordance with the national
wiring rules (AS/NZS 3000) for class 1, IP55 rated products.
These instructions are a guide only. Users not familiar with
pumping equipment should seek advice from people experienced
in pump equipment and installation.
Freezing conditions will damage the unit, because when water
freezes it expands. Ensure that the pump is located so that it is
not prone to freezing, or ensure that the product is disconnected
and dried of water during cold conditions.
IMH pumps are electrically connected. Ensure that they are
switched off and unplugged from socket outlet during installation
and any subsequent service work.
The pump is designed to be used with clean water in a residential
application. Do not use it with alternative fl uids, abrasive,
corrosive or explosive fl uids. Do not install or operate your pump
in an explosive environment or near combustible matter.
Incorrectly installed or tested equipment may fail, causing severe
injury or property damage.
Fire and burn hazard. Modern motors run at high temperatures. To
reduce risk of fi re, do not allow leaves, debris, or foreign matter
to collect around the pump motor. To avoid burns when handling
the motor, let it cool for at least 20 minutes before trying to work
on it. Automatic thermal overload cut-out protects the motor for
heat damage during operation and it will restart without notice
when the motor cools down.
The pump is not intended for use by young children or infi rm
persons without supervision. Young children should be supervised
to ensure that they do not play with the pump.
Read the following instructions in this owner's manual when installing and
operating equipment.
6