Operation - Pentair ONGA IMH750 Owner's Manual

Operation

The pump operator or owner must be provided with this owner's
manual. This must be read before operation, and followed during
operation.
Ensure that your pump is filled with water before operating.
Failure to do so may result in damage to the pump seals and
may void warranty.
The pump is designed to be used with clean water in a residential
application. Do not use it with alternative fl uids, specifi cally
abrasive, corrosive or explosive fluids. Do not install or operate
your pump in an explosive enviroment or near combustible
matter.
Fire and burn hazard. Modern motors run at high temperatures. To
reduce risk of fire, do not allow leaves, debris, or foreign matter
to collect around the pump motor. To avoid burns when handling
the motor, let it cool for at least 20 minutes before trying to work
on it. Automatic thermal overload cut-out protects the motor from
heat damage during operation and it will restart without notice
when the motor cools down.
1. Start-up / Operation
Ensure you have primed the pump correctly. (Instructions on priming the pump
can be found in the installation section under Point 8. Priming Pump).
Note: If the pump is not used for a long period of time, repeat the priming
procedure before start up.
Start the pump and check rotation of the motor. It rotates in a clockwise
direction when viewing the fan through the cowl behind the motor.
11