Orved CUISSON VMOSV31 Operating And Service Manual page 20

EN
USING THE APPLIANCE
8
WORK CYCLE START-UP : Lower the lid using both hands pressing it down lighlty at the corners. The appliance will start the work cycle
according to the set parameters.
9
WORK CYCLE END: The appliance automatically ends the cycle after the sealing bar phase and re-entry of air in the chamber with consequent
opening of the lid. Remove the packed product and check the seal; it must be uniform, well marked and without melted points. Adjust the preset
values, if necessary, and proceed with the second cycle.
Activate the button; the work cycle can be interrupted at any moment; interruption is immediate with air re-entering the chamber. The work
cycle can also be interrupted by means of the ON/OFF main switch: when the appliance is switched off, the cycle is interrupted but air does not
return to the suction cup: the lid therefore remains closed.
When the appliance is switched on again, the cycle is reset, air returns to the chamber and the lid opens.
ACTIVATION
- Press the key.
- Press the key, the display flashes alternately with "GAS" or "SI"; a few seconds later, the value set is displayed.
- Change the value using the cursor keys and/or confirm by means of
DEACTIVATION
- Press the key.
- Press the key, the set gas percentage appears on the display.
- Press the key again; the words "GAS" and "NO" flash alternately on the display; a few seconds later, the LED and the function are
deactivated.
1
Turn on the appliance and set the sealing value in accordance with the thickness of the bag to be used; deactivate the GAS function.
2
Press the key; the words "JAR" and "SI" flash alternately on the display. Position the bag about 20mm beyond sealing bar (A), then start
the cycle by lowering the lid (B).
3
When vacuum formation has been completed inside the bag, press
when air returns to the chamber and the lid opens.
A
EN
Operation and maintenance manual / Ed. 11 - 2008
INTERRUPTING THE WORK CYCLE
ACTIVATING AND DEACTIVATING THE GAS FUNCTION
PROGRAMMING THE "PUMP" FUNCTION
FOR VACUUM PACKING EMBOSSED BAGS OUTSIDE THE VACUUM CHAMBER
20 mm.
•
CUISSON SV-31 • SV-41
; the LED remains On and the function is activated.
. The appliance will proceed to the bag sealing phase. The cycle ends
46
B
•
REV. 01 - Cod.: 1500288