Ir Remote Control Operations; Pairing (Enabling) The Ir Remote To A Specific Device (Optional) - HIKVISION DS-96064NI-I16 User Manual

2 Status
indicator
3 USB interface
4 Panel lock
5 HDD sequence
indicator

IR Remote Control Operations

The device may also be controlled with the included IR remote control, shown in Figure 1-3.
Batteries (2×AAA) must be installed before operation.
The IR remote is set at the factory to control the device (using default Device ID# 255) without
any additional steps. Device ID# 255 is the default universal device identification number shared
by the devices. You may also pair an IR Remote to a specific device by changing the Device ID#,
as follows:
Pairing (Enabling) the IR Remote to a Specific Device
(optional)
You can pair an IR Remote to a specific device by creating a user-defined Device ID#. This feature
is useful when using multiple IR Remotes and devices.
On the device:
Go to System > General.
Type a number (255 digits maximum) into the Device No. field.
Network Video Recorder User Manual
Power Solid blue indicates device is powered on. Solid
red indicates device is shut down.

HDD Solid red: at least one HDD is installed

Unlit: no HDD is detected.

Flashing red: HDD is reading/writing.
Tx/Rx Flashing blue indicates network communication is
normal.
Ready Solid blue indicates device runs properly.
Alarm Solid red indicates alarm occurs.
Universal Serial Bus (USB) ports for additional
devices such as USB mouse and USB Hard Disk
Drive (HDD).
Locks or unlocks the panel by the key.
Shows the HDD installation slot.
18