Mercedes-Benz C-Clas 2016 Owner's Manual page 356

Vehicles with plastic hub cap:
To remove: turn the centre cover of hub
X
cap : anti-clockwise and remove.
To fit: before fitting, ensure that hub cap : is
X
in the open position. To do this, turn the
centre cover anti-clockwise.
Position hub cap : and turn the centre cover
X
clockwise until you feel and hear the hub
cap : engage.
Make sure that hub cap : is fitted securely.
X
Vehicles with aluminium hub cap:
To remove: take socket ; and wheel wrench
X
= from the vehicle tool kit (
Position socket ; on hub cap :.
X
Position wheel wrench = on socket ;.
X
Using wheel wrench =, turn hub cap : anti-
X
clockwise and remove.
To fit: before fitting, check hub cap : and
X
wheel area for dirt and clean if necessary.
Position hub cap : and turn until it is in the
X
right position.
Position socket ; on hub cap :.
X
Position wheel wrench = on socket ; and
X
tighten hub cap :.
The tightening torque must be 25 Nm.
i
the specified torque of 25 Nm. Mercedes-
Benz recommends that you have the hub cap
fitted at a qualified specialist workshop.
Using wheel wrench =, loosen the bolts on
X
the wheel you wish to change by about one
full turn. Do not unscrew the bolts completely.
The jacking points are located just behind the
front wheel arches and just in front of the rear
wheel arches (arrows).
Mercedes-AMG vehicles and vehicles with
AMG equipment: to protect the vehicle body,
the vehicle has covers fitted next to the jacking
page 325).
Y
points on the outer sills.
Changing a wheel
Note that the hub cap must be tightened to
353
Z