Ice Dispenser Tips - Frigidaire FSC23F7FW0 Use & Care Manual

Frigidaire fsc23f7fw0: user guide
Hide thumbs Also See for FSC23F7FW0:
Table of Contents

Advertisement

ICE AND WATER DISPENSER FEATURES
The ice and water dispenser conveniently dispenses chilled water, and ice cubes or crushed ice, depending on the model.
To operate the ice dispenser, select the ice option desired using the touchpad. Press a glass against the dispensing paddle as far
up as possible to catch all ice. To stop dispensing ice, pull glass away from dispensing paddle. Do not remove the glass until the
ice has completely dispensed. (Complete instructions for the dispenser operation are attached to the inside of the freezer door.)
How the Water Dispenser Works
The water tank, located behind the refrigerator compartment, automatically fills as water is dispensed. For proper dispenser
operation, the recommended supply water pressure should fall between 20 psi and 100 psi.
Water pressure must not exceed 100 lbs. Excessive pressure may cause water filter to malfunction.
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water. It may take about 1½
minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing the system for 3 minutes
to rid the tank and plumbing connections of any impurities. The water dispenser has a built in shutoff device that will stop the water
flow after 3 minutes of continuous use. Simply release the dispenser paddle to reset the shutoff mechanism.
Chemicals from a malfunctioning softener can damage the ice maker. If the ice maker is connected
to soft water, ensure that the softener is maintained and working properly.
How the Ice Dispenser Works

ICE DISPENSER TIPS

Ice cubes stored too long may develop an odd flavor. Empty the ice container and ensure that the ice maker's On/Off
power switch is turned On (set to the "I" position). The ice maker will then produce more ice.
Occasionally shake the ice container to keep ice separated.
Keep the ice maker's On/Off power switch turned Off (set to the "O" position) until the refrigerator is connected to the water
supply or whenever the water supply is turned off.
IMPORTANT: The ice maker is turned On at the factory so it can work as soon as you install your refrigerator.
connect a water supply, turn the On/Off switch to the Off ("O") position. Otherwise, the ice maker's valve may be noisy when
it attempts to operate without water.
If the dispensing paddle is pushed for more than 4 minutes, the dispenser motor may overload
and stop. The overload protector will reset automatically after 3 or 4 minutes.
If a large quantity of ice is needed at one time, it is best to remove cubes directly from the ice container.
The following sounds are normal when the ice maker is operating:
Motor running
Ice dropping into ice container
Water valve opening or closing
Turn Off the ice maker when cleaning the freezer and during vacations.
If the ice maker will be turned off for a long period of time, you should also turn off the water supply valve.
Automatic Ice and Water Dispenser
The ice maker and container are located in the top of the freezer compartment. After the refrigerator
is installed properly and has cooled for several hours, the ice maker can begin making ice within 24
hours. Air in new plumbing lines may cause the ice maker to cycle two or three times before making
a full tray of ice. Ice production is controlled by the ice maker's On/Off power switch. To gain access to
the ice maker, slide the ice cream tray out. Press the switch to the "O" position to turn it Off and press
it to the "I" position to turn it On. With no usage it will take approximately 2 days to fill the ice container.
The ice maker also has a built-in wire signal arm,which automatically stops ice production when the
ice bin is full. This signal arm should not be used to manually stop the ice maker.
The ice maker produces 4 to 6 pounds of ice every 24 hours depending on usage conditions. Ice is
produced at a rate of 8 cubes every 75 to 90 minutes
Because of new plumbing connections, the first production of ice cubes may be discolored or have
an odd flavor. These should be discarded until the cubes made are free of discoloration and taste.
Ice loosening from tray
Running water
14
If you cannot

Advertisement

Table of Contents
loading

This manual is also suitable for:

Phsc39egs

Table of Contents