Setting The Cutting Depth; Setting The Cutting Angle - Westfalia TSH165 Operating Instructions Manual

from the protective cover. When lifting the saw the motor slides back into the
initial position.

Setting the Cutting Depth

The cutting depth can be set between 0 – 54 mm:
1. Loosen the cutting depth limit stop knob (9) and
slide it to the desired cutting depth according to
the graduated scale (11) to set the cutting
depth.
Note: The graduated values on the scale (11)
apply for straight cuts (90° cut). The guide rail
track compensation (12) must be tilted up when
using the plunge saw without guide rail. Only
when using the plunge saw with guide rail the
guide rail track compensation is used to com-
pensate for the thickness of the guide rail.
Using the guide rail = guide rail track compen-
sation down.
Not using the guide rail = guide rail track
compensation lever up.
2. Tighten the cutting depth limit stop knob (9).
The motor or respectively the saw blade can
now be pushed down to the set cutting depth.
For a clean, safe cut set the cutting depth in
such a way that only max. one saw blade tooth
protrudes under the work piece.

Setting the Cutting Angle

The plunge saw can be swivelled between 0° and
48°:
1. Loosen both rotary knobs (8). Swivel the motor
to the desired cutting angle on the cutting
angle scale.
2. Tighten the rotary knobs (8) again.
Operation
30
(11)
(9
(10)
(8)
)