Reversible Door - Frigidaire FRT21TSGW2 User Manual

Frigidaire frt21tsgw2: user guide
Hide thumbs Also See for FRT21TSGW2:
Table of Contents

Advertisement

Reversible Door

Instructions
(continued)
Freezer Door
7. Reverse handles while doors are off. Remove the two screws
attaching the handle to the bottom of the freezer door. Remove
short trim piece by sliding the trim straight up and off of handle
bracket. Remove the screw attaching the top of the handle to
door, and reinstall on other side, using the same holes as the
nameplate. To move nameplate to other side, remove the
magnetic nameplate from its frame, turn frame upside down and
install in old handle holes. Insert magnetic nameplate into frame.
Reattach handle to bottom of door. Slide the trim piece straight
down onto handle bracket.
Refrigerator Door
8. Trim Removal (Full-Length Trim models only)
In some models, the refrigerator door has a full length trim
piece which continues from the bottom of the handle to the
bottom of the door. The top of the trim attaches to the
handle bracket. An adhesive "trim lock" is positioned about
half-way down. The bottom of the trim is held in place by
either an adhesive trim lock, or a trim lock with two prongs
inserted into a hole on the face of the door. Remove the trim
by gently pulling the trim lock areas out and away from the
door. When the trim is free from the door, slide the trim
straight down and away from the handle bracket.
For models with short handle trim, remove by sliding the
trim straight down and off of handle bracket.
To remove handles: Remove the three screws attaching
the handle to the refrigerator door. Carefully remove hole
plugs from corresponding holes on opposite side of doors
and reattach handle.
To reattach trim: Slide both trim locks out of trim. Insert
the new adhesive trim locks contained in your literature
pack. NOTE: Trim lock must be removed and installed by
sliding OVER the two donut shaped areas. Install trim to
handle by sliding up over bottom of handle. Carefully align
trim and press down at trim lock locations. Replace hole
plug on opposite side. Use rubbing alcohol to remove any
adhesive residue from old trim lock location(s).
For models with short handle trim, slide the trim straight up
onto handle bracket.
1 0

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents