Frigidaire FRT21TSGW2 User Manual page 13

Frigidaire frt21tsgw2: user guide
Hide thumbs Also See for FRT21TSGW2:
Table of Contents

Advertisement

OCCURRENCE
WATER/MOISTURE/FROST INSIDE REFRIGERATOR
Moisture collects on inside of refrigerator
walls.
Water collects on bottom side of drawer
cover.
Water collects in bottom of drawer.
WATER/MOISTURE/FROST OUTSIDE REFRIGERATOR
Moisture forms on outside of refrigerator
or between doors.
(some models)
AUTOMATIC ICE MAKER
Ice maker is not making any ice.
SCREEN
INLET, WATER LINE
OUTLET TO ICE MAKER
Ice maker is not making enough ice.
Ice maker will not stop making ice.
Ice maker is not separating the cubes.
Ice has bad odor and taste.
ODORS IN REFRIGERATOR
OPENING/CLOSING OF DOORS/DRAWERS
Door(s) will not close.
SOLUTION
Weather is hot and humid which increases rate of frost buildup and internal sweating. This is normal.
Door is slightly open. See Occurrence section
Door is opened too often or too long. Open the door less often.
Vegetables contain and give off moisture. It is not unusual to have moisture on the bottom side of
the cover.
Washed vegetables and fruits drain while in the drawer. Dry items before putting them into drawer.
Water collecting in bottom of drawer is normal.
Weather is humid. This is normal in humid weather. When humidity is lower, the moisture should
disappear. Set Energy Saver switch to the Reduce Exterior Moisture position.
Door is slightly open, causing cold air from inside the refrigerator to meet warm air from outside.
See Occurrence section
Ice maker wire signal arm is in "up" or OFF position. Move wire signal arm to "down" or ON position.
Household water line valve is not open. Turn on household water line valve.
BRASS FITTING
Water supply valve in refrigerator is being blocked by foreign material. Unplug the refrigerator and
turn off water supply. Slide refrigerator out and locate where water is connected to the valve.
Unscrew the brass fitting and pull out the screen from inside the valve mesh. Clean the screen of
foreign material. Replace screen and brass fitting and turn the water supply on; check for leaks. Plug
in refrigerator and slide into place.
Freezer is not cold enough. See Occurrence section
Saddle valve on cold water pipe is blocked or restricted by foreign material. Turn off household water
line valve. Remove, clean or replace valve.
Ice maker is producing less ice than you expect. Ice maker should produce approximately
2 1/2 to 4 pounds of ice every 24 hours.
Freezer is not cold enough. See Occurrence section
Household water line valve is not completely open. Turn on household water line valve.
Water supply valve in refrigerator is being blocked by foreign material. See Occurrence, "Ice maker
is not making any ice" above.
Ice maker wire arm is being held down by an item in the freezer. Remove item and release arm.
Remove any ice cubes which are frozen together over arm.
Ice cubes are not being used frequently enough. Remove and shake ice bucket to separate cubes.
Ice has picked up odor or flavor from strong food stored in refrigerator or freezer. Cover foods tightly.
Discard stale ice. Ice maker will produce fresh supply.
Water running to ice maker has poor taste or odor. Add filter to ice maker. Consult a water
purifying company.
Interior needs to be cleaned. Clean interior with sponge, warm water and baking soda.
Food with strong odor is in refrigerator. Cover food tightly.
Door is not designed to swing shut automatically. Close door securely.
Door was closed too hard, causing other door to open slightly. Close both doors gently.
Refrigerator is not level. It rocks on the floor when it is moved slightly. Be sure floor is level and solid
and can adequately support refrigerator. Adjust rollers as needed.
/
/
OPENING
CLOSING OF DOORS
DRAWERS
1 3
/
/
.
OPENING
CLOSING OF DOORS
DRAWERS
.
.
TEMPERATURES ARE TOO WARM
.
TEMPERATURES ARE TOO WARM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents