Technical Data; Installation; Electrical Connection - IKEA ANRATTA Manual

ENGLISH

Technical data

Model identification: ANRÄTTA 905.082.64
Supply Voltage
Rated Power Input
Fuse
MW output power
Grill
Convection
Outer dimensions (HxWxD)
Cavity inner dimensions (HxWxD)
The technical informations are situated in the rating plate inside the appliance.
Data for test heating performance in accordance with IEC 60705.
The International Electrotechnical Commission has developed a standard for comparative
testing of heating performance of different microwave ovens.
We recommend the following for this oven:
Test
12.3.1 Egg custard
12.3.2 Sponge cake
12.3.3 Meatloaf
13.3 Meat defrost
NOTE: this information is only for the qualified technician.

Installation

Mounting the appliance
Follow the supplied separate mounting instructions when
installing the appliance.
Installation and repairs must be carried out by a qualified
technician, in compliance with the manufacturer's instructions
and local safety regulations. Do not repair or replace any part
of the appliance unless specifically stated in the user manual.
Children should not perform installation operations. Keep
children away during installation of the appliance. Keep the
packaging materials (plastic bags, polystyrene parts, etc.) out
of reach of children, during and after the installation of the
appliance.
Use protective gloves to perform all unpacking and installation
operations.
The appliance must be handled and installed by two or more
persons.

Electrical connection

Prior to connecting
Check that the voltage on the rating plate corresponds to the
voltage in your home.
The rating plate is on the front edge of the oven (visible when
the door is open).
Do not remove the microwave inlet protection plates located on
the side of the oven cavity walls. They prevent grease and food
particles from entering the microwave inlet channels.
Ensure the oven cavity is empty before mounting.
Ensure that the appliance is not damaged.
Amount Approx. time
750 g 11 - 12 min
475 g 9 min
900 g 16 - 18 min
500 g 14 min
Power level Container
650 W Pyrex 3.227
650 W Pyrex 3.827
800 W Pyrex 3.838
160 W
The appliance must be disconnected from the power supply
before carrying out any installation operation.
After unpacking the appliance, make sure that it has not been
damaged during transport. In the event of problems, contact
the dealer or your nearest After-sales Service.
After unpacking the appliance, make sure that the appliance
door closes properly.
In the event of problems, contact the dealer or your nearest
After-sales Service. To prevent any damage, only remove the
oven
from its polystyrene foam base at the time of installation.
During installation, make sure the appliance does not damage
the power cable.
Check that the oven door closes firmly against the door support
and that the internal door seal is not damaged. Empty the oven
and clean the interior with a soft, damp cloth. Do not operate
this appliance if it has a damaged mains cord or plug, if it is not
working properly, or if it has been damaged or dropped. Do not
immerse the mains cord or plug in water. Keep the cord away
from hot surfaces. Electrical shock, fire or other hazards may
result.
After connecting
The oven can be operated only if the oven door is firmly closed.
Regulation require that the appliance is earthed.
The manufacturer will accept no responsibility for injury to
persons, animals or damage to objects arising from the non-
observance of this requirement.
The manufacturers are not liable for any problems caused by the
user's failure to observe these instructions.
220-240 V/50 Hz
2300 W
10 A
1000 W
800 W
397 x 595 x 468
200 x 405 x 380
12