THOMSON TG587n v2 Setup And User Manual page 104

3 Wireless Access
3.2 Connecting Your Wireless Client without WPS
Before you start
Before you can connect a computer to your wireless network you need to know which Network Name (SSID)
and wireless encryption your Thomson Gateway is using.
What Network Name (SSID) is the Thomson Gateway using?
If you did not change the SSID manually, your Thomson Gateway uses the SSID that is printed on the bottom
panel label of your Thomson Gateway.
What wireless security is the Thomson Gateway using?
You have not yet configured your Thomson Gateway
In this case, no encryption is used.
You have already configured your Thomson Gateway using the Guided Installation
If you choose to use the wireless settings proposed by the Setup wizard, you can find the encryption key/
passphrase on the label on the bottom of your Thomson Gateway.
Forgot your wireless settings?
If you have changed the wireless settings manually and you can't remember your settings, try one of the
following:
If one of your computers is already connected to your network:
1 Browse to the
2 On the Home Network menu, click Wireless.
3 In the upper-right corner, click Details.
4 Under:
Configuration, you can find the network name (SSID).
Security, you can find the encryption.
If none of your computers is connected to your network, connect a computer using a wired connection and
follow the procedure above to find out what your wireless settings are.
Another option is to reset your Thomson Gateway and reconfigure it all over again. For more information,
see "6.5 Reset to Factory Defaults" on page
Procedure
Configure your computer with the same wireless settings as your Thomson Gateway. For more information,
consult the help of your wireless client.
24
Thomson Gateway GUI on a computer that is already connected to your network.
54.
E-DOC-CTC-20090105-0001 v0.1