Related Manuals for Black & Decker GTC5455PC
Summary of Contents for Black & Decker GTC5455PC
- Page 1 GTC5455PC www.blackanddecker.com.au GTC5455PCB www.blackanddecker.co.nz...
- Page 2 GTC5455PC only Charging Fully Charged Hot/Cold Pack Delay Bad Battery...
- Page 3 0-15...
-
Page 4: Intended Use
There is an increased risk of electric shock if your body is earthed or grounded. Your BLACK+DECKER GTC5455PC, GTC5455PCB hedge c. Do not expose power tools to rain or wet conditions. trimmers have been designed for trimming hedges, shrubs Water entering a power tool will increase the risk of and brambles. - Page 5 (Original instructions) ENGLISH d. Remove any adjusting key or wrench before turning b. Use power tools only with specificall designated the power tool on. A wrench or a key left attached to a battery packs. Use of any other battery packs may create rotating part of the power tool may result in personal injury.
-
Page 6: Residual Risks
ENGLISH (Original instructions) Vibration Never attempt to force the blades to come to a standstill. Do not put the tool down until the blades have come to a The declared vibration emission values stated in the technical complete standstill. data and the declaration of conformity have been measured Regularly check the blades for damage and wear. -
Page 7: Charging Procedure
When disposing of batteries, follow the instructions given 10. Dualvolt battery pack (Only with GTC5455PC unit) in the section "Protecting the environment". 11. Dualvolt battery LED indicator (Only with GTC5455PC unit) 12. Charger (Only with GTC5455PC unit) Do not attempt to charge damaged batteries. -
Page 8: Operation
ENGLISH (Original instructions) Check current at receptacle by plugging in a lamp or or too cold, it automatically starts a Hot/Cold Pack Delay, other appliance. suspending charging until the battery pack has reached an Check to see if receptacle is connected to a light switch appropriate temperature. -
Page 9: Maintenance
(Original instructions) ENGLISH blade, in the direction of motion gives the best cutting. ing. Warning! Do not cut stems greater than 19mm. Use the The cutting blades are made from high quality, hardened steel trimmer only for cutting normal shrubbery around houses and and with normal usage, they will not require resharpening. -
Page 10: Protecting The Environment
40 degree F (4.5°C) or below 105 degree F (+40.5°C). Protecting the environment Separate collection. Products and batteries GTC5455PC, GTC5455PCB Hedge Trimmer marked with this symbol must not be disposed of with normal household waste. Black & Decker declares that these products described under "technical data"... - Page 11 (Original instructions) ENGLISH Australia & New Zealand St Stanley Black & Decker www.blackanddecker.com.au www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
- Page 12 03/2017 N524920...