ENGLISH (Original instructions) Intended use 3. Personal safety a. Stay alert, watch what you are doing and use common Your BLACK+DECKER GTC36552PC, hedge trimmer has sense when operating a power tool. Do not use a been designed for trimming hedges, shrubs and brambles. This tool is intended for consumer use only.
Page 5
(Original instructions) ENGLISH e. Maintain power tools. Check for misalignment or while operating the tool can result in serious personal binding of moving parts, breakage of parts and any injury. other condition that may affect the power tools Carry the hedge trimmer by the handle with the cutter operation.
ENGLISH (Original instructions) Safety of others Warning! To reduce the risk of injury, the user This appliance can be used by children aged from 8 years must read the instruction manual. and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if Wear safety glasses or goggles when operating they have been given supervision or instruction concern-...
(Original instructions) ENGLISH Chargers The battery may become warm while charging; this is normal and does not indicate a problem. Always check that the mains voltage corresponds to the Warning! Do not charge the battery at ambient temperatures voltage on the rating plate. below 10 °C or above 40 °C.
ENGLISH (Original instructions) Warning! Shock hazard. Do not allow any liquid to get inside When the charger detects a battery that is excessively charger. Never attempt to open the battery pack for any hot or excessively cold, it automatically starts a Hot/Cold reason.
(Original instructions) ENGLISH Insert two screws into the openings on the side of the Note: Once the button is released, the blades will immediately guard, tighten securely. return to full speed. Slide the bail handle (6) onto the front of the trimmer Note: The blades will stop when the button is held for 15 housing behind the guard as shown in Figure F.
ENGLISH (Original instructions) local provisions. Further information is available at Troubleshooting www.2helpU.com Problem Possible Cause Possible Solution Slow running, Dry, corroded Lubricate blades. Technical data noisy or hot blades. blades. Blade or blade Straighten blade or GTC36552PC (H1) support bent. blade support.
Page 12
Australia & New Zealand Stanley Black & Decker www.blackanddecker.com.au www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) 90630152 04/2016...