Display Readings - Splash And Auto Off Screen - Noyes AFL OPM5-2D User Manual

W dB/dBm/µW key

dB
Provides two functions:
dBm
• Press to toggle test readings between insertion loss in dB and power in dBm A .
• Press and hold to view power in µW B .
WAVE ID
Set Ref/Set key
Ref
Provides two functions:
• Press to display the stored reference level for the currently selected wavelength or
multiple wavelengths.
• Press and hold until HELD SET is displayed to store the currently measured level or
multiple levels as the new reference levels. Once the new reference is set, the OPM5
switches to the dB measurement mode.
Store key
Store
Provides two functions :
• Test mode: press this key to save the currently displayed measured data in the next
available memory location (next Fiber) of the current File.
• File/Fiber/Recall/Clear mode: press this key to return to the Test mode.
Recall key
Recall
Press this key to enter the Recall mode that allows viewing and deleting stored test records.
Press again to exit the Recall mode.
Clear
Store Recall
The Clear mode screen may be accessed and used as follows:
Clear

Display Readings - Splash and Auto Off Screen

8888
8888
12
OPM5 Models
8888
nm
-88.88
µW
dB dBm
8888
Hz
nm
-88.88
µW
dB dBm
• From the File mode screen to delete a file
• From the Recall mode screen to delete a fiber
Splash (Version) screen: During power up, the OPM5
A
software version is shown on the top line A . The OPM type
and detector type are shown on the next line B . The Splash
B
screen will be automatically replaced by the Test screen after
~ 2 seconds.
Auto Off screen: When the unit is about to power off due to
inactivity, then display will show "OFF" B and count down
the number of seconds until power will be shut off.
B
A
B
A