Philips AVENT SCF356 User Manual page 10

ENGLISH
12
Note: The progress indicator shows the progress of the milk
warming process. The progress indicator starts flashing
when the appliance is on. When the first warming phase has
been completed, the bottom segment lights up continuously
and the next segment starts flashing to show that the
second warming phase is in progress. These steps continue
until the third warming phase has been completed. Then the
entire progress indicator lights up continuously.
Note: During the warming process, the milk circulates to
ensure even warming. It takes about 10 minutes to warm
90ml/3oz of room-temperature milk. It takes slightly longer
to warm cold milk or a large amount of milk.
Caution: Do not take the bottle out of the baby bottle
warmer while the progress indicator is flashing.
7
When the entire progress indicator lights up
continuously, the milk has reached the set temperature.
-
When the milk is warm, you can either take the bottle out
of the baby bottle warmer to feed your baby right away
(see section 'Feeding your baby immediately') or you can
keep it warm in the baby bottle warmer (see section
'Keeping milk warm').
Increasing the milk temperature
1
If you want the milk to be warmer, you can increase the
milk temperature gradually after it is ready by switching
to milk warming setting 3 and leaving the bottle in the
appliance at the keep-warm mode (Fig. 9).
2
If you just switched off the baby bottle warmer or if it just
switched off automatically, switch it back on without
removing the warm water from it, and follow the above
step (Fig. 10).
3
The baby bottle warmer switches off automatically after
20 minutes of keep-warm mode (Fig. 11).