Non-2Wire Wireless Adapter Configuration - 2Wire 2701HGV Installation Manual

Connect the First Computer to the Gateway

Non-2Wire Wireless Adapter Configuration

Locating the Serial Number and Wireless
Encryption Key
The serial number of your 2Wire gateway is used as the network name (SSID). Beneath the serial number is
a ten-digit number which is used as the encryption key. These are located on the bottom of your gateway
(shown in vertical orientation). You will need this information to configure your wireless adapter.
SN: 145511100110
2Wire Gateway
®
www.2Wire.com
Made in Malaysia
Patent No. Des. 437,289
5,1V 3A
RG2701HGV-00
Configuring the Adapter
Install and configure your wireless adapter according to the manufacturer's instructions.
1.
Use the network adapter configuration software or Windows network connection wizard to set the
2.
network name (SSID) and encryption key (WEP).
a. The network name is the word "2WIRE" (in all capital letters), followed by the last three digits of the
gateway serial number (for example, 2WIRE110).
b. The encryption key is a 64-bit hex value, located beneath the bar code on the bottom of the 2Wire
gateway. In the example, it is 4119627022.
c. For Mac OS X users, you may need to enter the "$" character at the beginning of the encryption key
(for example, $4119627022).
2701HGV
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
Concentrador Inalambrico
This device may not cause harmful interference, and (2)
para Red (ADSL)
Marca: 2Wire
this device must accept any interference received,
Modelo: RG2701HGV-00
including interference that may cause undesired operation.
6