Disassembly Instructions - Mitsubishi Electric Mr. Slim SUZ-SA71VA Technical & Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
SUZ-SA71VA.TH
OPERATING PROCEDURE
1. Removing the cabinet
(1) Remove the screws of the service panel.
(2) Remove the screws of the top panel.
(3) Remove the screw of the valve cover.
(4) Remove the service panel.
(5) Remove the top panel.
(6) Remove the valve cover.
(7) Disconnect the power supply and indoor/outdoor connect-
ing wire.
(8) Remove the screws of the cabinet.
(9) Remove the cabinet.
(10) Remove the screws of the back panel.
(11) Remove the back panel.
Photo 2
Screws of the top panel
Screws
of the
cabinet
Screws of the
service panel
Screw of
the valve
cover
OCH561
1Slide the sleeve.
2Pull the terminal while
pushing the locking
lever.
Screw of the back panel
Screws of the
cabinet
Screws of the
back panel
(2) The terminal with this connector has the
locking mechanism.
Connector
NOTE: Turn OFF power supply before disassembling.
Photo 1
Screws of the top panel
Screws of the
cabinet
29 29
1Hold the sleeve, and
pull out the terminal
slowly.
PHOTOS
Screws of the
cabinet