KTM 890 DUKE 2021 Owner's Manual page 108

17 COOLING SYSTEM
106
–
Position the motorcycle upright.
–
Position an appropriate container under the engine.
–
Remove screw
V01254-11
–
Remove radiator cap
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw plug,
water pump
drain hole
A00957-11
–
Remove bleeder screw
–
Tilt the vehicle slightly to the right.
–
Pour in coolant until it emerges without bubbles at the vent
hole, and then mount and tighten bleeder screw
ately.
Coolant
–
Completely fill the radiator with coolant. Mount radiator
2
cap .
A00958-11
–
Rest the vehicle on the side stand.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and run it until the 5th bar of the temperature
indicator lights up.
–
Stop the engine and allow it to cool down.
–
After the engine has cooled down, check the coolant level in
the radiator and in the compensating tank again and add more
coolant if necessary.
1
with the seal ring.
2
.
1
with a new seal ring.
EJOTALtracs ® 8 Nm (5.9 lbf ft)
Plus 60x14
3
.
1.6 l (1.7 qt.) Coolant (
Loctite 243™
®
3
immedi-
p. 130)