Installation; 1093/151Wm1A → Wifi Bullet Fixed Lens Camera; 1093/152Wm1A → Wifi Bullet Varifocal Camera; 1093/181Wm1A → Wifi Mini Dome Camera - urmet domus 1093 User Manual

3

INSTALLATION

1093/151WM1A → WIFI BULLET FIXED LENS CAMERA
3.1
It is advisable to proceed as follows for correct camera installation and configuration:
1. Make sure that no units are powered before starting the installation procedure. Fit the aerial and the top on the camera.
It is advisable to install and configure one camera at a time if you are installing multiple cameras on the same network.
2. Connect the camera to the network (see section 4). It is advisable to check that the WiFi signal received by the camera
is higher than or equal to 60.
3. Position the camera in a point on the wall or other surface and adjust the bracket to frame the required scene.
4. If you want the camera to record and store video files on a micro SD card (not included), plug the card into the slot when
the camera is powered off (see the picture below). Power on the camera and use the camera's wepgabe or the app to
format the card before starting the recording function.
5. If you are using a NVR/HVR device, assign a static IP address to the camera and use the NVR/HVR menu to add the
camera to a recording channel.
1093/152WM1A → WIFI BULLET VARIFOCAL CAMERA
3.2
It is advisable to proceed as follows for correct camera installation and configuration:
1. Make sure that no units are powered before starting the installation procedure. Fit the aerial and the top on the camera.
It is advisable to install and configure one camera at a time if you are installing multiple cameras on the same network.
2. Connect the camera to the network (see section 4). It is advisable to check that the WiFi signal received by the camera
is higher than or equal to 60.
3. Position the camera in a point on the wall or other surface and adjust the bracket to frame the required scene. Make sure
that the frame and the zoom level is correct. Adjust the bracket again and lock it in its final position.
4. If you want the camera to record and store video files on a micro SD card (not included), plug the card into the slot when
the camera is powered off (sse the picture below). Power on the camera and use the camera's wepgabe or the app to
format the card before starting the recording function.
5. If you are using a NVR/HVR device, assign a static IP address to the camera and use the NVR/HVR menu to add the
camera to a recording channel.
1093/181WM1A → WIFI MINI DOME CAMERA
3.3
It is advisable to proceed as follows for correct camera installation and configuration:
1. Make sure that no units are powered before starting the installation procedure. It is advisable to install and configure one
camera at a time if you are installing multiple cameras on the same network.
2. Connect the camera to the network (see section 4). It is advisable to check that the WiFi signal received by the camera
is higher than or equal to 60.
3. Remove the protection dome by turning it on the base. Make 3 fixing holes (for false ceiling mounting, make also a 15mm
diameter hole for passage of cables), using the minidome as drilling template.
6
FIXING HOLES
DS1093-607