Table of Contents
Advertisement
CHAPTER 4
MAINTAINING YOUR CAPTURE BOARD
To clean the reflective bezels and corner sensors—Method 2
1. Spray a small amount of water or cleaner onto a clean lint-free cloth or paper towel.
IMPORTANT
Acceptable cleaners include water, Windex glass cleaner and isopropyl alcohol.
o
Starting at the corners, wipe inwards to avoid wiping dry erase residue and dust onto
o
the corner sensors
2. Using a clean, moistened lint-free cloth, gently wipe the corner sensors at the bottom of the
capture board. Ensure the bezel and corner sensors are free of dust and residue.
Cleaning your eraser
The eraser can be used to erase ink from the capture board surface. Over time, the eraser felt
collects dry erase ink residue and becomes less effective at erasing.
To clean the eraser felt
1. Rinse the eraser felt under cold running tap water.
2. While wearing gloves, apply a mild soap or detergent and rub the eraser felt with your fingers.
3. Rinse the eraser felt thoroughly under cold running tap water
4. Remove excess water by pressing the felt against a towel or paper towel.
5. Allow the eraser felt to air dry completely.
Transporting your capture board
Save your original packaging to repack your capture board if needed. This packaging was
designed with optimal shock and vibration protection. If your original packaging isn't available, you
can purchase the same packaging directly from your authorized SMART reseller.
CAUTION
Transport your capture board only in original or replaced packaging. Transporting your capture
board without correct packaging voids your warranty and could lead to product damage.
Replacing the markers and eraser
Your SMART kapp 42" capture board comes with three dry erase markers and one eraser.
Your SMART kapp 84" capture board comes with six dry erase markers and one eraser.
29
smarttech.com/kb/170769
Advertisement
Table of Contents
