Table of Contents
Advertisement
Preventive Care
(continued)
NO TE
Depending on the application, it may be
necessary to move the feeder from original
installation so as to access gate assembly.
Cleaning schedule for various materials:
• Typical: every month
• Dusty: after every shift
• High ink or varnish: 1 time per shift
V
S
V-710iJ M
alue
erieS
anual
Cleaning Gate Assembly
Use only isopropyl alcohol (98% concentration). Do not use any
other types of solvents. They can cause premature wear of the
belts, or even total breakdown of the material.
To clean gate assemblies:
1. Turn Off feeder and remove power cord from outlet.
2. Remove gate assembly from gate bracket assembly.
3. Apply a small amount of isopropyl alcohol to a soft cloth.
4. Wipe across O-rings, or angled wedge if applicable. First wipe
in one direction, then the other.
5. Taking a dry portion of the cloth, go back and wipe all sur-
faces to ensure they are dried.
6. Reinstall gate assembly and restore power. It may be neces-
sary to recheck alignment of feeder with host machine if
feeder was moved from original installation position (for a
review, refer back to Section 2, "Installing the Machine").
29
Advertisement
Table of Contents
